Avalon Firestyles 564 HO GS2 Installation - Manual (Page 29)

Installation (
for qualified installers only)
29
Travis Industries 4150330 100-01408
Vent Configurations with Vertical Termination (Dancing/DiamondFyre)
NOTE: Travis Industries
strongly recommends using a
6-5/8” diameter vent when
terminating vertically.
 The termination must fall
within the shaded area
shown in the chart. Use the
indicated restrictor and
diffuser positions.
 Up to four elbows (45° or
90°) may be used.
 Only one horizontal elbow
may be used.
.
H1
H2
This is considered a horizontal
elbow (it does not matter
whether it turns right or left).
It may be a 90° or 45° elbow.
This is considered a vertical elbow.
Horizontal length (max. 24’) is calculated
by adding both lengths of horizontal run
(Horizontal Length = H1 + H2).
5 feet (1.5m)
0 feet
0 feet
5 feet (1.5m)
0 feet
20 feet (6m) 20 feet (6m)
5 feet (1.5m) 10 feet (3m)
5 feet (1.5m) 10 feet (3m
)
0 feet
15 feet (4.5m)
20' max (6m)
10 feet (3m)
15 feet (4.5m)
15 feet (4.5m) 20' max (6m)
10 feet (3m)
15 feet (4.5m)
40' max (12m)
25 feet (7.5m)
30 feet (9m)
35 feet (10.5m)
40' max (12m)
25 feet (7.5m)
30 feet (9m)
35 feet (10.5m)
Exhaust Restrictor #1
Intake Restrictor #1
Diffuser #1
Exhaust Restrictor #2
Intake Restrictor #3
Diffuser #2 (OPEN)
Exhaust Restrictor #4
Intake Restrictor #3
Diffuser #2 (OPEN)
Exhaust Restrictor #5
Intake Restrictor #5
Diffuser #2 (OPEN)
Exhaust Restrictor #5
Intake Restrictor #6
Diffuser #2 (OPEN)