Avalon Firestyles DVL Insert EF-2002 to 2005 - Manual (Page 13)

Installation
(for qualified installers only)
1 3
Travis Industries 4 0 4 1 0 2 8 1 0 0 - 0 1 1 5 1
Installation Without Surround Panels
a
b
c
Keep the jumper wire in
place while installing.
Disconnect the on/off switch from
the red and brown wires. Insert
the switch into the hole until it
locks in place. Re-attach the red
and brown wires (orientation does
not matter).
Use a knife to cut out the on/off switch hole
(the label covers a square hole in the bracket).
Use a lock tie or
other device to
bundle the
excess wire.
Then tuck it
below the piezo
igniter to keep it
from coming in
contact with the
burner pan.
The insert may be installed without surround panels if a 3/8" gap is
allowed between the sides and top of the face and the fireplace (for
ventiliation). Wire mesh screen may be placed over this gap.
Min. 3/8"
Face Dimensions
See “Face Sizing” on page 9.
Surround Panel Installation
PANEL SIZE W I D T H H E I G H T
8" x 10" Rectangular 44-3/16" 33-3/8"
Arched (8” x 10”) 44-3/16" 33-3/8"
10” x 13” Rectangular 48-3/16" 36-3/8"
1 Follow the
instructions
to the right
for installing
the side
panels.
Line up each side surround
panel and insert two screws from
the inside to secure in place.
b
a
5/16" Nutdriver
Pre-thread the holes on the surround
panels with the screws included in the
surround panel kit.
Run the wires from
the on/off switch and
the power cord
behind the surround
panel (cut the lock-
tie holding the on/off
switch in place).