Operation, Before you begin, Location of controls - see explanation below – Avalon Firestyles DVL Insert EF-2002 to 2005 User Manual

Page 22

Advertising
background image

2 2

Operation

Travis Industries

4 0 4 1 0 2 8

1 0 0 - 0 1 1 5 1

Before You Begin

!

Read this entire manual before you use your new heater (especially the section "Safety Precautions"
on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even
death.

Location of Controls - See explanation below

Open the access door

to view the controls.

Gas Control Valve

Gas Control Knob Flame Adjust Knob

An instruction card for operating the
fireplace is attached to the inside of the
fireplace here. Replace it for easy
reference.

PILOT

IGNITER

Pilot Igniter

BLOWER

CONTROL

LO

OFF

Blower Knob

HI

ON/OFF Switch

O

F

ON

F

The on/off switch is
located on the
upper right corner
of the surround
panels.

The Pilot Flame can be
found below the back log.

Blower Knob

This knob controls the speed of the internal convection blower that pushes
the heated air into the room.

On/Off Switch

This control is used to turn the heater on and off.

Pilot Igniter

The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.

Gas Control Knob

This knob is used to control gas to the heater and for starting the pilot. There
are three positions, ON, OFF, & PILOT. The pointer directly below the knob
indicates the position this knob is in.

Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The pointer

to the upper left of the knob points to the position this knob is in.

If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off
Switch "OFF" will keep the heater off always.

Advertising