Avalon Firestyles DVL Insert EF-2002 to 2005 - Manual (Page 15)

Installation
(for qualified installers only)
1 5
Travis Industries 4 0 4 1 0 2 8 1 0 0 - 0 1 1 5 1
Manifold Removal and Installation
• The manifold is shipped attached to the insert, but may be removed to facilitate especially tight
installations. See the directions below for installation.
1 Remove the manifold and place it within the fireplace (see the instructions on the following page).
2 Route the flex vent through the chimney from above (leave an extra 3' (914 mm) at the top).
3 Attach the flex vent to the manifold (seal with silicone and attach with screws).
4 Place the manifold in an upright position (so it rests on the manifold legs) and have a partner pull on
the excess flex vent. Temporarily attach the flex vent to the top of the chimney (leave extra slack).
5 Slide the insert into place, guiding the convection top over the insert until fully in place.
6 After removing any slack from the flex vent, attach the manifold to the appliance.
7 Remove any excess slack in the flex line then attach the vent termination.
4
4
3
2
1
5
7
6