Avalon Firestyles DVL Insert EF-2002 to 2005 - Manual (Page 7)

Installation
(for qualified installers only)
7
Travis Industries 4 0 4 1 0 2 8 1 0 0 - 0 1 1 5 1
Installation Warnings:
! Failure to follow all of the requirements may result in property damage, bodily
injury, or even death.
! This heater must be installed by a qualified installer who has gone through a
training program for the installation of direct vent gas appliances.
! This appliance must be installed in accordance with all local codes, if any; if not,
follow ANSI Z223.1 and NFPA 54(88) in the USA and B-149 in Canada.
! In Manufactured or Mobile Homes must confirm with: In USA, Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280; In Canada, CSA Z240.4
and Gas-Equipped Recreational Vehicles and Mobile Housing. This appliance may
be installed in Manufactured Housing only after the home is site located.
! The DVL Insert is designed to operate on natural gas (NG) or propane (LP).
! All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
! Notify your insurance company before hooking up this heater.
! The requirements listed below are divided into sections. All requirements must be
met simultaneously. The order of installation is not rigid – the qualified installer
should follow the procedure best suited for the installation.
Additional Items Required for Installation
• 6-5/8” to 3” & 4” Co-Linear Adapter – W/ Flashing (Travis Part # 98900124)
• Face
• Gas Hookup Equipment
• Surround Panels (Optional - see “Installation without Surround Panels”)
• 3” and 4” Diameter Gas Liner
• Direct Vent Cap (Simpson Duravent Part # 991)
Packing List
• DVL Insert
• Log Set (Log Set, Coals, and Embers)
• Owner's Manual
• Two Leveling Bolts
• Propane Conversion Kit
• "Fireplace Altered" tag (attach to the fireplace)
• 8" Pipe Inlet (3/8" dia.)
• Door Latch Key
• Block Off Plate
• (2) Fireback Clips (for ceramic firebacks only)
Items Packed with the Face
• Face (with attachment hardware) • Face Installation Instructions
Order of Installation
1 If the heater is to use propane, install the propane conversion kit (see page 32)
2 Install gas line into the fireplace (do not connect to unit)
3 Position the heater (see "Insert Placement")
4 Connect the gas line and gas vent to the appliance.
5 Install the optional surround panels and trim. Attach the on/off switch.
6 Follow the instructions under "Finalizing the Installation" on pages 17 through 21.