Avalon Firestyles DVL Insert EF-2002 to 2005 - Manual (Page 14)

1 4
Installation
(for qualified installers only)
Travis Industries 4 0 4 1 0 2 8 1 0 0 - 0 1 1 5 1
Surround Panel Installation (continued)
2 Follow the instructions below for installing the top panel, insulation, and trim.
Install the top panel so
the two tabs insert into
the slots on the side
panels.
Top
Panel
Top Trim
"L" Bracket
Double-Back
Tape
Right Side Trim
Construct the panel trim. Insert one leg of
each "L" bracket into the top and side trim
piece. Align the trim to form a precise corner,
then tighten the two set screws with a small
standard screwdriver. Slide the trim over the
panels. Attach a piece of included double-
back tape to the bottom of each side trim to
keep it from flaring at the bottom.
Tighten the set screws from the
back side with a small standard
screwdriver
"L" Bracket
Right Side
Trim
Top Trim
c
b
a
Tuck the included insulation between
the top panel and the facing below
the rheostat (not along the sides).
Cut off excess insulation.
Slot for on/off
switch
(rectangular or
arched)
WARNING: The insulation must be installed
along the top of the insert and should cover or
be below the rheostat (to protect it from heat).
Failure to install the insulation will invalidate
facing and mantel clearances, creating a fire
hazard.
NOTE:
On arched
panels make
sure these
stand-offs are
perpendicular
and not bent
over or
flattened.
3 Install the on/off switch following the directions below.
Upper
Right
of Trim
Keep the jumper wire in
place while installing.
Disconnect the on/off switch from the red and brown
wires leading from the heater. Insert the switch into
the hole in the upper right of the panel trim until it locks
in place. Re-attach the red and brown wires
(orientation does not matter).