Aviosys 9258HP - Manual (Page 26)

- 26 -
Name:
This section lists out the ports of the device. If a name has been selected in the power control
section they will appear here instead of the default names.
Action Enable / Disable:
In this section you can turn enable or disable the ping function for each individual output.
Host Name / IP Address:
Input the IP Address or web address of the IP you would like to ping.
Select the action that you would like the Ping Function to use when the device being Ping cannot
be located or is not responding.
Ping Failures:
Select the number of Ping Failures that you would like to occur before the action is activated. The
reddish pink number to the right represents the actual number of ping failures. Keep in mind that
four consecutive pings equals to 1 Ping failure.
Example:
Say you have Port 2 set to 2 Ping failures this is what would happen:
Port 1: Pings with no failure the device will move to Port 2
Port 2: If Port 2 has a Ping failure it will continue Pinging until 4 unsuccessful ping with equals 1
failure.
Ping failure is now 1
Then it moves to the next port. (When it reaches the designated Ping failures then the action will
happen)
Port 3: Pings with no failure the device will move to Port 4
Port 4: Pings with no failure the device will move to Port 1
Port 1: Pings with no failure the device will move to Port 2