Aviosys 9258HP - Manual (Page 27)

- 27 -
Port 2: If Port 2 has a Ping failure it will continue Pinging until 4 unsuccessful ping with equals 1
failure.
Ping Failure is now 2
9258 will do the action and reset Port 2 by Turning the port off first
Then since you have set the timer to 1 minute and 20 seconds, the device will turn back on the
port in that time.
Note: The timer is usually used for devices that have a boot up time this will prevent the device from
continuously resetting the device attached
Then the 9258 will continue to then next port and continue this cycle.
Port 3: Pings with no failure the device will move to Port 4
Port 4: Pings with no failure the device will move to Port 1
Wake-up Settings :
The section allow you to auto wake up the assigned PC ( with setting MAC ) in LAN by the times
of " Ping Failures " .
To enable the " wake up setting" , you need to assign the MAC address of controlled device in "
PC Control Settings " of " Power Control Settings" as following :
First : Click " PC Control settings " of "Power Control settings " and set the MAC address plan
to ping and click "Save" bottom.