Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part1 - Manual (Page 67)

UPPER THREADING
G
etting
Re
ad
y
65
1
k
Continue threading however do not pass
the thread in the needle bar thread guide
“6” on the needle bar. Thread the needle on
the right side.
a Needle bar thread guide
l
Select a stitch pattern. (Example: )
* Refer to “Sewing a Stitch” on page 80 for selecting
the stitch.
* Refer to the “STITCH SETTING CHART” at the end
of this manual for the proper stitch to use with
presser foot “J”.
→ The selected stitch is displayed.
m
Press to select the twin needle mode.
a Single needle/twin needle setting
→
appears.
n
Start sewing.
Sample of Twin Needle Sewing
Using the Spool Stand
The included spool stand is useful when using
thread on spools with a large diameter (cross-
wound thread). This spool stand can hold two
spools of thread.
■ Using the Spool Stand
• Be sure to use a spool cap that is slightly larger
than the spool.
If the spool cap that is used is smaller or much
larger than the spool, the thread may catch and
sewing performance may suffer.
Note
• If the key is light gray after selecting
the stitch, the selected stitch cannot be
sewn in the twin needle mode.
CAUTION
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
a
Memo
• To change direction when sewing with the
twin needle, raise the needle from the
fabric, raise the presser foot lever, and then
turn the fabric.
Memo
• See page 24 to assemble the spool stand.
• See page 56 to wind the bobbin when using
the spool stand.