Baby Lock Anna (BL20A) Instruction and Reference Guide - Manual (Page 26)

20
q
w
e
r
t
y
z
x
c
v
Inserting the bobbin
z Place the bobbin in the bobbin holder with the
thread running off as illustrated.
q Thread
x Guide the thread into the front notch on the
front side of thebobbin holder. Draw the
thread to the left, sliding it between the
tension spring blades.
w Front notch
e Tension spring blade
c Continue to draw the thread lightly until the
thread slips into the side notch.
r Side notch
v Pull out about 4” (10 cm) of thread.
Attach the hook cover plate by inserting the 2
prongs on left of the hook cover plate into the
openings. Lower the right side until it clicks
into place.
Check the threading by referring to the chart
shown on the hook cover plate.
t Thread
y Hook cover plate