Baby Lock Anna (BL20A) Instruction and Reference Guide - Manual (Page 52)

46
c
t
q
w
y
z
x
r
e
Corded Buttonhole
Machine setting
q Stitch pattern:
w Stitch length: 0.5 – 1
e Thread tension: 1 – 5
r Presser foot: Sliding buttonhole J
z With the buttonhole foot raised, hook the filler
cord on the spur at the back of the foot.
Bring the ends toward you under the foot,
clearing the front end.
Hook the filler cord into the forks on the front
of the foot to hold them tight.
q Spur
w Forks
x Draw both of needle and bobbin thread to
the left.
Move the slider toward you so that the top
mark
r on the slider meets the start arrow e .
e Start arrow
r Top mark
t Needle thread
y Bobbin thread
Lower the needle into the fabric at the starting
point and lower the foot.
Depress the foot control gently and sew the
buttonhole over the cord.
The sewing sequence is the same as the
4-step buttonhole.
c Pull the left end of the filler cord to tighten it
and cut the excess tails.
To cut the buttonhole opening, refer to the
instructions on page 44.
w
e
r
q