Basler Electric BE1-50/51B - Manual (Page 6)

iv BE1-50/51B Introduction 9252000991 Rev R
Manual
Revision and Date
Change
H, 02/96  Incorporated changed in series 200 relays that added five
characteristic curves and changed switch SW8-3 functionality.
 Changed Section 5, Testing, to incorporate setting all sections of
switch SW8.
G, 10/95  Corrected minor typographical errors in Section 1 and 2.
 Corrected Table 2-1, locator item K, Function.
 Changed Figure 5-2 and all testing target current source references
from 0.2 ampere to 1.0 ampere.
 Changed Table 7-1 to add ECA and date data.
F, 02/95  Changed all sections to reflect 200 series relay additions and relay
modifications that deleted P2 and P3 jumpers and added switch
SW8.
 Changed Specifications, TIME and ISNT PICKUP accuracy; Output
Circuits, and Isolation (Dielectric Test).
E, 09/94  Corrected Figure 4-8.
D, 05/94  Clarified TIME PICKUP and INST PICKUP specification ranges,
page 1-3.
 Changed Figure 1-2 to also show one ampere unit burden data.
 Changed time characteristics accuracy statement, page 1-6.
 Added (repeated) equation for the characteristic curve time
functions, page 1-8.
 Changed Figure 1-4 to show one ampere unit starting data.
 Separated Section 4, Installation, into Section 4, Installation, and
Section 5, Testing, and bumped all subsequent sections.
C, 06/93  Added column for CT secondary to Table 1-1 and UL Recognition
and CSA Certification to specifications.
 Page 3-2: Deleted “or reset” from last sentence in paragraph
Outputs. Changed from “The targets will not operate or reset…” to
“The targets will not operate…”
 Page 4-1: Corrected dielectric test leakage current per terminal.
B, 09/92  Page 1-1: Application, deleted reference to dust tight cover.
 Page 1-3: Specifications, TIME Dropout to not less than 95% of
pickup value.
 Page 1-6: Specifications, Time Reset, added statement to insure
sufficient power to power-up relay when using decaying
characteristic.
 Page 1-7: Specifications, corrected Storage Range Temperature
degrees F.
 Page 1-8: Defined British Standard curve types.
 Page 2-1: INST and TIME PICKUP selectors, added statement that
changing selectors while relay is in service may cause tripping.
 Page 4-4: Changed Figures 4-4 and 4-5.
 Page 4-6: Changed Figure 4-8.
 Page 4-9: Time Pickup Test, Step 1, changed 0.45 A to 0.485 A.
 Page 4-11: Time Pickup Test, Step 1, changed 0.09 A to 0.096 A.
 Page 4-13: Added paragraph SETTING THE RELAY.
 Added Section 6.
A, 05/92  Changed manual title to BE1-50/51B and incorporated engineering
changes accordingly.