Becker MAP PILOT OPERATION GUIDE - Manual (Page 34)

34
>>> NAVIGATION MODE
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> RUS
Calling up the map display
The map display is called up automatical-
ly when you start route guidance.
Without route guidance, you can call up
the map display using the main menu or
by pressing and holding down button
L in the main menus.
> Select Map from the main menu.
The map display will then appear and, if
GPS reception is available, will show your
current position.
If route guidance is already active, the
map will be displayed with route guid-
ance.
Structure of the map display
The structure depends on the settings
made in “Map display” on page 42 and
whether route guidance is active or not.
Map display without route guidance
If the navigation is not active, almost the
whole area of the display will be taken up
by the map.
Speed limit on the road currently be-
ing driven on (display not available
for all roads), signs for the driver
alerts will also be displayed
Number of satellites currently being
received
Vehicle position
Current road
Map display with route guidance
Road signs, which you should follow
Speed limit on the road currently be-
ing driven on (display not available
for all roads)
Driver alerts
Number of satellites currently being
received
Display of TMC status
Vehicle position
1
3
4
2
1
2
3
4
Note:
The information in the left area is only
displayed when action must be taken.
Otherwise the destination arrival time -
and stopover arrival time, if applicable - is
displayed in the lower left area.
1
5
10
9
8
2
3
4
7
6
1
2
3
4
5
6