Using the battery, Connecting to the cigarette lighter – Becker TRAFFIC ASSIST Z101 User Manual

Page 16

Advertising
background image

16

>>>

GERNARAL OPERATION

> D

> GB

> F

> I

> E

> NL

Using the battery

The internal power supply is via the inte-
grated rechargeable battery. The recharge-
able battery is maintenance-free and does
not require any particular care.

Connecting to the cigarette

lighter

Power supplies using a vehicle battery are
connected up as follows using the cable sup-
plied for the cigarette lighter.
> Hold the USB socket at the corrugated

grip area and push it into the connect-
ing socket on the Traffic Assist or into
the connecting socket on the carrier
plate as far as the stop, without using ex-
cessive force.

> Plug the plug adapter into the cigarette

lighter.

Note:
Note that if the battery is completely dis-
charged, it may take up to a minute be-
fore the device can be switched on again.

Note:
In the event of a defective battery, please
contact your authorised dealer. Please do
not attempt to remove the battery your-
self.

Note:
If the cigarette lighter has just been used
and is still warm, wait until this has
cooled down in its mounting.

Note:
If the engine is switched off, using
the vehicle's power supply through the
cigarette lighter will slowly drain
the vehicle battery! Do not therefore op-
erate the Traffic Assist for extended peri-
ods with the engine off.

Advertising