Becker TRAFFIC ASSIST Z101 - Manual (Page 20)

20
>>> GERNARAL OPERATION
> D
> GB
> F
> I
> E
> NL
On the windscreen
The unit holder can be attached directly
to the windscreen via the suction mecha-
nism.
> Find a suitable position.
> Press the base
with its suction sur-
face against the windshield.
> Rotate the unit bracket so that the sup-
port plate is roughly in the direction of
viewing required.
> Press the lever downwards.
The bracket will have stuck firmly to the
windscreen. It can now be set precisely.
To remove, actuate the lever
again.
Adjusting the unit bracket
> Unscrew the fastening screw until
the carrier plate can be moved with-
out excessive force.
> Move the carrier plate to the re-
quired position and hold it in this posi-
tion.
> Tighten the fastening screw suffi-
ciently so that the Traffic Assist is held
securely in place when the vehicle is in
motion.
Adding the Traffic Assist
> Position the Traffic Assist with the at-
tachment points on the bottom of the
housing on the carrier plate
.
> Press the Traffic Assist onto the carrier
plate without using excessive force
until the clip engages in the attach-
ment point.
Removing the Traffic Assist
Press the clip
on the unit holder with
one finger and remove the unit from the
unit holder using your free hand.
Switching the Traffic Assist
on/off
The unit is switched on and off using the
key .
Switching on
> Press the key for a few seconds.
The unit is switched on. The manufactur-
er's logo appears on the touch screen.
3
1
2
2
4
5
5
4
5
5
6
6