Beisler 2112-4 - Manual (Page 14)

Short Seam Automat 2112-4 Working Instructions
- B 14 -
Beisler Automated Sewing Equipment
B.2
Functions of the machine
Fig. 2/3
Fig. 2
Fig. 3
B.2.1 Sewing functions of the machine
The short seam automat 2112-4 can perform three diffe-
rent, automated sewing functions:
•
Crimping over of the pocket edge and sewing the pok-
ket edge to a pocket bag.
• Clipping and crimping over of the left slash selvage with
subsequent sewing of the slash selvage to the left trou-
sers component.
• Sewing the slash selvage to the right trousers compo-
nent.
B.2.2 Pocket edge function
The machine cycle "Sewing on pocket edge" is performed
as follows:
•
Pocket edge and pocket bag are positioned manually.
• The pocket edge is crimped over and picked up.
• The folder transports the pocket edge to the pocket bag.
• The transport system automatically transports the pok-
ket edge and the pocket bag to the sewing head where
they are tucked.
• The finished piece is transported to the stacking table
by the stacking system and put down.
B.2.3 Lining up pocket edge/pocket bag
Depending on how the pocket edge and the pocket bag
are to be sewn to one another, the two pieces must be ali-
gned at the line-up positions. The exact line-up position
of the edge to the bag can be marked at the working plate
or at the pick-up plate using tape or pen. Please note that
the pocket bag must be lined up within the operating range
of the pocket bag clamp (Fig. 3, 4).
Handwheel for stitch width, Fig. 2:
The handwheel 1 is used to set the correct stitch width
for the pocket edge. The stitch width depends on the
thickness of the fabric. The thicker the fabric, the lar-
ger the stitch width.
Line-up position for pocket edge, Fig. 3:
The pocket edge 1 is lined up at the stop rail 3 of
the pick-up plate. The exact alignment to the pocket
bag is marked by a marking 2 at the pick-up plate.