Beisler 2112-4 - Manual (Page 98)

Short Seam Automat 2112-4 Working Instructions
- D 98 -
Beisler Automated Sewing Equipment
D.3
Programming
D.3.12 Level 2 special parameters / Lists
Setting upper part parameters:
This list is used for setting all parameters for functions of
the sewing head.
The minimum and maximum values of input are limited
by the program control unit. Values that are not within the
limits will not be accepted but reduced to the correspon-
ding minimum or maximum value.
• Press
? key.
The parameter list is shown on the display.
NOTE - Sewing speed!
Possible settings for the sewing speed refer to the follo-
wing sewing ranges:
•
Sewing speed 1 to the start distance,
• sewing speed 2 to the center distance,
• sewing speed 3 to the end of the seam.
The speed is set in increments of 100 rpm.
Setting stitch lengths and bar tacks:
All settings for the configuration of the seam can be chan-
ged using this list.
The minimum and maximum values of input are limited
by the program control unit. Values that are not within the
limits will not be accepted but reduced to the correspon-
ding minimum or maximum value.
• Press
3 key.
The parameter list is shown on the display.
Parameters for clamp transport:
This list is used to make all settings for the clamp move-
ment.
• Press
8 key.
The parameter list shown on the display has the following
function:
01 Clamp insertion as seen from right end of rail
02 Stop position 600 mm is a safety value. Only values
higher than 600 mm can be input
03 Settable range: 35 % - 80 %
04 Settable range: 35 % - 99 %
05 Range of the curve where no sewing is performed. If
value "0" is input here, the sewing process starts im-
mediately.