Beisler 2112-4 - Manual (Page 85)

- D 85 -
Short Seam Automat 2112-4 Working Instructions Beisler Automated Sewing Equipment
D.3
Programming
D.3
Programming
D.3.3 Service menu level 1
Functions on level 1
The function keys on the start level are assigned to the
symbols above them as shown on the display.
The settings of the global parameter menu (GP) and of
the special parameter menu (SP) which can also be re-
quested from this level are described in separate sections.
&'(6 )@7

F1 Back to start level
F2 Request global parameter menu
F3 Request special parameter menu
F4 Set seam sequence
F6 Reset day counter to zero
F7 Manual winding
F8 Select machine control inputs / outputs
Setting the seam sequence:
The settings refer to the selected sewing program. The
sequence for sewing the seams can be set at will. When
the sequence is set, existing seam numbers are overwrit-
ten or new seam numbers are written.
• Press
 key.
6
• Press  key.
The display shows the marking of the sewing program and
the seam numbers.
01 01 02 03 04
Mark seam number to be changed using cursor:
01 01 02 03 04
Open overwrite function:
• Press
% key.
Enter new seam number using numeric keypad:
01 01 04 03 04
Confirm input and exit menu:
• Press
 key.
The display shows the new seam sequence.
01 01 04 03 04
Erase seam number:
• Mark seam number using cursor, then delete
Confirm erasure and exit menu:
• Press
 key.
NOTE - Seam sequences!
Just as the seam sequence can be selected at will, a seam
can be written into a sewing program once or several ti-
mes. A sewing program may consist of up to six seams.
Resetting the day counter to zero:
This function is used to reset the day counter for a pro-
duction cycle to zero.
• Press  key.
)
• Press
 key.
The display counter is now reset to zero.
Display: PART: 0000