Beisler 2112-4 - Manual (Page 95)

- D 95 -
Short Seam Automat 2112-4 Working Instructions Beisler Automated Sewing Equipment
D.3
Programming
D.3.10 Level 4 special parameters / Functions
Level 4 submenus:
&D - GHI9,

F1 Back to level 3
F2 Enable/disable vacuum
F4 Enable/disable working plate rear cutter (left trou-
sers component)
F5 Enable/disable working plate front cutter (right trou-
sers component)
F6 Enable/disable pick-up plate front cutter (left slash
selvage)
F7 Sewing to fixed end-of-seam position
F8 Request next level (level 5)
Enabling or disabling vacuum
The vacuum is used as a fixing aid for the left or right trou-
sers component before the clamp transport transfer. It can
be disabled during the checking of machine movements.
To enable or disable this function:
D
• Press  key.
NOTE - Operation without vacuum!
During normal production operation, the vacuum should
always be enabled as otherwise failures in the machine
cycle may occur.
Enabling or disabling cutters
Both sewing programs for the left and right slash selva-
ge (M01/ seam 12, 11) have been programmed at the fac-
tory with an individual cutter cut. For specific seams, this
function can be enabled or disabled separately:
1. Working plate rear cutter (left trousers component).
G
• Press
 key.
2. Working plate front cutter (right trousers component).
H
• Press
 key.
3. Pick-up plate cutter (left slash selvage).
I
• Press
 key.
Sewing to fixed end-of-seam position
If this function is enabled, a fixed position for the end of
the seam can be programmed for the sewing of the slash
selvages:
9
• Press
 key.