Bluelab Dosetronic Peridoser Kit - Manual (Page 26)

22
Version P1.3 : 151012
Bluelab Dosetr
onic P
eridoser Kit
Bluelab Corporation Limited
Temperature Required /
Alarms
Temperature control works slightly
different from conductivity and pH.
This is because temperature is hard
to maintain constantly. For example
if you are heating your greenhouse
the “temperature on” value will turn
on the heater and “temperature off”
will turn the heater off when these
temperature values are sensed.
Temperature Control On
Temperature Control Off
Temperature Control Off
If using a
Temperature Lower / Cooling Device
If using a
Temperature Raise / Heating Device
Temperature off
Alarm High
Temperature on
Alarm Low
AL.H1
AL.LO
30
26 24 26
22
24°C
26°C
Note:
It is normal practice to set your temperature
on time to continuous. The following page
shows you how to do this. This allows
the heater/cooler to operate until the
temperature off value is reached.