Bluelab Dosetronic Peridoser Kit - Manual (Page 31)

27
Version P1.3 : 151012
Bluelab Dosetr
onic P
eridoser Kit
Bluelab Corporation Limited Bluelab Corporation Limited
3
18 18
3.11 Control
Control mode monitors your
Actual readings and adjusts them
to the Required values you have
programmed in the Required/
alarms mode. It does this through
the dosing systems installed.
Note: It is advised that you go
through “Preparing system to
run” in the next chapter before
setting the system in control
mode.
1. Select Control
Press up and down keys to
select mode.
2. Controller will adjust nutrient,
pH and temperature levels
accordingly.
When the system is dosing and
the values are being adjusted
the control direction indicator
lights will fl ash.
6.5
18
1 6.8
16
1.3
Actual Required
0.1
Note: If an actual value is fl ashing
in control mode and your dosing
system is not dosing it may be
because the value is outside of
the control range. This can be
changed by manually increasing
your nutrient levels in the stock
tank. For more information see the
troubleshooting section.