Bolide SVR9000D - Manual (Page 30)

User Manual
29
5.3.7 System
5.3.7.1 General
Click [Main Menu System General] to enter into the interface shown as Picture 5-43.
You will be allowed to modify system date, time, date/time format, language, video format and Menu time out.
And click [DST Setup] button to enter into the below interface shown as Picture 5-44.
5.3.7.2 DST Set
Enter into the interface shown as Picture 5-48 and you are allowed to set DST status and mode.
5.3.7.3 Network Time Protocol (NTP) Service
Click [Main menu System General NTP] to enter into the interface shown as Picture 5-45
5.3.7.4 Users
Click [Main Menu System users] option and then enter into the interface shown as Picture 5-46.
The model supports up to seven users with one Admin and seven users.
Click [Edit] button to enter into the [User Edit] interface shown as Picture 5-47
NTP Service：Allow you enable/disable the NTP function.
Server Address: currently support three servers, including
time.windows.com, time.nist.gov and pool.ntp.org.
Time Zone: System supports thirty Time Zones.
Update now: Click [Update Now] button to change the above
NTP set.
Note: The above change will be available only when system
connected to internet. And When NTP function is set to
“Enable”, system will calibrate the time at every 00:07:50 and
every start-up
You could select the channel you desire to control and set
PTZ protocol (Pelco-D or Pelco-P), Baud Rate (1200, 2400,
4800, 9600), Data bit (8, 7, 6, 5), Stop bit (1, 2), Parity Check
(None, Odd, Even, Mark, Space), Address Code and Cruise
status respectively. Please note the PTZ device can be
activated only when a channel in connection with the PTZ
camera is selected.
Picture 5-42
Picture 5-43 Picture 5-44
Picture 5-45