Brinly STH-420 BH Lawn Sweeper - Manual (Page 15)

1009727-A 15.
ASSEMBLY
================================================================================================
29 66
37
35
3
37
5 33
35
36
37
Figure 12
With the sweeper attached to the towing vehicle (see
‘Attaching the Sweeper’ section of this manual), connect
the Hamper Assembly to the sweeper using the hardware in
Panel 12 (see Figure 12.1).
Tie one end of Hamper Pull Rope (37) to the middle section
of the upper Rear Hamper Tube (66) as shown (see Figure
12.1).
Thread Pull Handle (35) onto opposite end of the Pull Rope
(37) as shown (Figure 12.2).
Extend Pull Rope (37) to the back of the towing vehicle
to an area that will be easily accessible from the towing
vehicle seat. This is the area that the Pull Handle (35) will be
attached.
Allow the Pull Rope (37) to slacken several inches (droop
between the towing vehicle and tied point on the Hamper –
Figure 12.3).
In the area of the Pull Rope (37) determined above, tie 2
knots and pull the knots into the Pull Handle (35) (Figure
12.2).
Clean the area of the towing vehicle that the Pull Handle (35)
will attach to.
Affi x the adhesive Hook and Loop (36) tape to the back of
the towing vehicle in the cleaned area.
Cut excess rope if needed.
Important: Pull Rope and Handle can get tangled
in the sweeper brushes if they fall on the ground
in front of the sweeper during operation. After
dumping the hamper, always make sure to fully
secure the Pull Handle to the back of the towing
vehicle using the Hook and Loop tape.
Slacken
Two Knots
To Towing
vehicle
To Sweeper
Figure 12.1
Figure 12.2
Figure 12.3
Maximum Towing Speed: 5 mph
Hamper Capacity: 20 cu. Ft.
Maximum Hamper Weight: 120 lbs
Empty Weight: 75 lbs
Maximum Towed Weight: 195 lbs
SPECIFICATIONS
================================================================================================