BUG-O Systems BGW-5000 - Manual (Page 19)

19
3.8 Electric flux winch
A 220VAC power winch is mounted on a “L” post at the roof of the Girth welder, it provides a max. lifting
capacity of 170 kg ( 375 lbs.) to lift welding flux up to 30m (98')[standard] below the Girth welder.
Please refer to the power Winch manual for details.
IV. INSTALLATION AND OPERATION
Correct installation and setup are critical to ensure proper operation of the BGW and welding equipment.
4.1 Frame Setup
4.1.1 Remove the machine from the crate. A lifting device capable of lifting 2000 kg (4409 lbs.) is required.
Place a crane hook to the lifting eye and carefully upright the machine.
4.1.2 Remove the location pins of the four square tube members of the GIRTH WELDER; use the lifting
device to adjust the height of the GIRTH WELDER to the size of the shell plate.
Relock the location pins when the appropriate position (pin holes) is found and apply a locking pin to secure
the location pin at the appropriate pin holes on the square tubes.
These pin holes are drilled in an interval of 100mm ( 3 15/16").