Chapter 2 – DFI COM101-BAT User Manual
Page 14
Advertising
www.dfi .com
Chapter 2 Hardware Installation
14
Chapter 2
Wake-up Test
J8
1 2
1 2
This jumper is used to simulate a general purpose wake-up signal such as wake-up on PS/2
keyboard or PS/2 mouse. Set J8 pins 1 and 2 to On to send WAKE# signal to the module.
1-2 Off: Normal
(default)
1-2 On:
Wake-up test
Thermal Trigger
J9
1 2
1 2
1-2 Off: Normal
(default)
1-2 On:
Thermal Trigger
This jumper is used to simulate the signal status that indicates an Over Temperature Situation.
Set J9 pins 1 and 2 to On to send THRM# signal to the module.
Advertising