Chapter 2 – DFI COM101-BAT User Manual
Page 27
Advertising
www.dfi .com
Chapter 2 Hardware Installation
27
Chapter 2
Switches
Reset
• Lid: it is used to turn the LVDS on or off.
• Sleep: it is used to set the system to “sleep” or “wake-up” mode.
Power
Lid
Sleep
Note:
The Sleep and Lid functions are supported only when your operating system supports
ACPI.
Serial Interface Connector
The serial interface connector is used for 2 serial ports supported by Tx and Rx signals.
Serial Interface 0/1 (Rx/Tx)
TX0
RX0
GND
TX1
RX1
GND
1
4
3
6
Advertising