DFI COM101-BAT - Manual (Page 25)

www.dfi .com Chapter 2 Hardware Installation
25
Chapter 2
Cooling Fan Connector
The fan connector is used to connect a cooling fan. The cooling fan will provide adequate air-
flow throughout the chassis to prevent overheating the system board components.
System Fan
1 3
Sense
Power
Ground
Standby Power LED
Standby Power LED
This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC then unplug the power cord prior to installing any de-
vices. Failure to do so will cause severe damage to the motherboard and components.