DFI COM101-BAT - Manual (Page 24)

www.dfi .com Chapter 2 Hardware Installation
24
Chapter 2
Front Panel Connector
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
ATX-SW - ATX Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system’s power is On, in the S1 (POS - Power On Suspend) state or in the S3 (STR
- Suspend To RAM) state, this LED will light.
1
2 11
12
HDD-LED
RESET-SW
PWR-LED
ATX-SW
Pin Pin Assignment Pin Pin Assignment
N.C. 1 N.C.
PWR-LED
2 LED Power
HDD-LED
3 HDD Power 4 LED Power
5 Signal 6 Signal
RESET-SW
7 Ground
ATX-SW
8 Signal
9 RST Signal 10 Ground
N.C. 11 N.C. Key 12 Key
Front
Panel