DFI COM330-B - Manual (Page 27)

27
2
Hardware Installation
1
ON
4 5 1
ON
4
5
PS/2 Mouse and Keyboard Port
PS/2 Mouse
and keyboard
(option)
These ports are used to connect a PS/2 mouse and a PS/2 keyboard. The PS/2
mouse port uses IRQ12.
Wake-On-PS/2 Keyboard/Mouse
The Wake-On-PS/2 Keyboard/Mouse function allows you to use the PS/2 key-
board or PS/2 mouse to power-on the system. To use this function:
• Jumper Setting
JP1 must be set to “2-3 On: +5V_standby”. Refer to “PS/2 Power Select” in
this chapter for more information.
• BIOS Setting
Configure the PS/2 keyboard/mouse wake up function in the Advanced menu
(“ACPI Power Management Configuration” submenu) of the BIOS. Refer to
chapter 3 for more information.
Important:
The +5V_standby power source of your power supply must support
≥720mA.