Diamondback Fitness 510Ub - Manual (Page 10)

10
10. Identify the left and right pedals. The ends of the pedal axles are
marked with an “L” for left and “R” for right. Install the right pedal
(E‐R) into the right crank by hand, rotating the axle in a clockwise
direction.
11. Thread the left pedal (E‐L) into the left crank by hand in a counter‐
clockwise direction.
12. Use the enclosed 15mm pedal wrench to firmly affix the pedals to
the cranks.
13. Retighten pedals after approximately ten (10) hours of use.
14. Tighten the left and right crank hex bolts (D‐16) with the enclosed
hex wrench. Re‐tighten after approximately ten (10) hours of use.
15. Slide the clamp on the underside of saddle (H‐1) onto
knurled post at the top of the seat post (H) and tighten the
nuts on either side firmly and evenly using the enclosed
wrench.
16. Slide the entire seat post assembly into the main frame seat
tube by un‐threading the adjuster knob (D‐6) [located on
the right side of the seat tube] a few turns. Pull outward,
away from frame and slide the assembly into the frame.
Adjust the seat to preferred height and release the knob.
17. Do not extend the post beyond the minimum insertion
mark (MAX) stamped into the post.
18. Ensure the post is fixed in place, and tighten knob.