Diamondback Fitness 510Ub - Manual (Page 13)

510Ub Owner’s Manual
13
34. Remove the six (6) Phillips screws (A‐1) from
the backside of the console (A) and set aside.
35. Feed wire connectors C‐14 & C‐16 through the
backside of the console hinge cover (A‐2).
36. While supporting the console (A), join
connectors A‐3 & C‐16. Join connectors A‐4
with C‐14. Ensure that all connections are
firm.
37. Tilt the console mounting plate (A‐5) toward
the rear of the unit.
38. Install two (2) Phillips screws (A‐1) through the
underside of the console mounting plate and
into the backside of the console. The screws
should be installed through the uppermost
pair of holes as displayed in Fig. 1 to the left.
39. Align the console hinge cover (A‐2) with the
mounting holes on the backside of the console
by sliding the cover’s slots over the base of
the hinge mount. It may be necessary to tuck
any extra cables into the console mast.
40. Re‐install the four (4) Phillips screws (A‐1)
through the backside of the console hinge
cover (A‐2) and tighten firmly.
41. Bring the upper console mast covers (C‐11 &
C‐12) together over the top of the console
mast (as shown in Fig. 2. to the left) and install
the four (4) Phillips screws (I‐10).
42. Install the two (2) Phillips screws (C‐13)
through the covers (C‐11 & C‐12) and into the
console mast.
Fig. 1.
Fig. 2.