Diamondback Fitness 510Ub - Manual (Page 9)

510Ub Owner’s Manual
9
ASSEMBLY INSTRUCTIONS
1. Unpack the 510Ub from the carton. Please recycle.
2. Verify the carton contains all parts from the
list.
3. Remove the short section of steel tubing from the
front stabilizer receiver by removing the two (2)
hex fixing bolts with the enclosed wrench. Discard
this item.
4. Thread the four (4) stabilizer feet (F‐5) into the
underside of the front and rear stabilizers (F & G).
5. Align the front stabilizer assembly (F) with the
receiver mounted to the frame and loosely install
two (2) sets of the hex bolt and curved washer
assemblies (I‐8 & I‐9) through frame and into the
front stabilizer (F).
6. Loosely install two (2) sets of the hex bolt and flat
washer assemblies (I‐8 & I‐7) through the
underside of the frame receiver and into front
stabilizer (F).
7. Align the rear stabilizer (G) with the frame and
loosely install two (2) sets of hex bolt and curved
washer assemblies (I‐8 & I‐9) through frame and
into the rear stabilizer (G).
8. Loosely install two (2) sets of hex bolt and flat
washer assemblies (I‐8 & I‐7) through underside of
the frame receiver and into rear stabilizer (G).
9. Tighten all eight (8) hex bolts (I‐8) firmly with
provided hex wrench to fix the front and rear
stabilizers.