Scope, Input status/output status, Status filter – GAI-Tronics Elemec3 Portal User Manual - Version 1.2 User Manual
Page 36
Pub. 42004-485A
Elemec3 Portal User Manual Version 1.2
Page 34 of 35
f:\standard ioms - current release\42004 instr. manuals\42004-485a.docx
02/14
Scope
To filter the displayed I/O points, select I/O Controller.
Link Status Filters – When checked, the Status Filter selection applies to both the Inputs and Outputs
panels.
Figure 48. System I/O Status screen (showing the I/O Controller selection drop down box)
Input Status/Output Status
System Input and Output Status panels display each I/O point in the selected scope and its current state:
ACTIVE
IDLE
FAULTED
INHIBITED
Status Filter
A Status Filter is available on both the Input and Output Status panels.
All – shows all Inputs/Outputs
Active/Faulted Only – Either panel can be filtered to show only the input or output points that are
active/faulted.