Standard Horizon HX-300 - Manual (Page 29)

Page 29 HX300
M
eMory
S
can
P
riority
S
can
Priority Scan: Scans the Scan Memory Channel,
Preset Channel, and the Priority
Channel (Channel 16).
Memory Scan: Scans the Scan Memory and chan-
nels programmed into the Preset
Channel memory.
6. After completing your selection, turn the transceiver
off and on by press and holding the key.
6.9.3 OPERATION
The operation of the “Priority Scan” or “Memory Scan” is determined via the
section “ 6.9.2 SELECTING THE SCAN TYPE”
6.9.3.1 Priority Scan
1. Press the key two times until the “
SQL” indicator blinks, to activate
the squelch adjusting mode, then press the / key until the back-
ground noise disappears.
2. Press the key to start scanning, a “ ” icon and
blinking “ ” and “ ” icons will appears on the dis-
play during scanning.
3. When the HX300 receives a transmission on a work-
ing channel, it will stop on the working channel and
“Dual Watch” (described in next chapter) to the prior-
ity channel until the incoming signal disappears, then
start scanning again.
4. When the HX300 receives a signal on the Priority
channel it will stay on this channel until the incoming
signal disappears, then start Priority scanning again.
5. To stop the scanning, press the key.