Datamax 123 Print v1.1x - Manual (Page 110)

Copyright © 2007 • MCL Technologies • All Rights Reserved
www
.mcl-collection.com
Chapter 3 : Creating a Project
3.5. System Setup
General introduction This section describes the settings for your 123 Print project.
Different settings are possible according to your printer display type.
Setup To enter System Setup, you must first have a project open. Then,
Click the System Setup button on the left-hand
side of the main window or on the menu bar:
1 Click Project
2 Click System Setup
Text Display When you select System Setup for a text display printer, the Aux Com
Settings window is displayed as shown here. These are the only project
related settings for a text display printer project. See Section 3.5.2 –
Auxiliary Communications for Aux Com Settings setup.
Graphical Display When you select System Setup for a graphical display printer, the
System Settings window is displayed as shown here. Notice that there
are also buttons for Soft Keys setup and Aux Com setup. See
Section
3.5.1 - Soft Keys Setup and Section 3.5.2 - Auxiliary Communications .
October 2007 Page 110