Lynx Studio LT-MADI User Manual
Page 12
Page 9
10.
Secure LT-MADI with three screws; one on the standoff and two from the back panel of
Aurora. Keep screws loose until LT-MADI is properly aligned, then tighten snugly, but
do not overtighten.
11.
Reinstall the Aurora lid using the eight screws that had been removed. Do not over
tighten the small screw near the center of the front faceplate as it is easily damaged.
12.
Plug in and power up the Aurora using the front panel standby switch. You can see the
LT-MADI from the slits in the Aurora lid. If LED6 on the LT-MADI lights up green,
then the installation was successful. If LED6 does not light, unplug the Aurora and re-
mount the LT-MADI, making sure that it is securely attached. Then plug in and power up
again. If LED6 still does not light, contact Lynx Customer Support (714-545-4700
extension 206).