Maytag WED9051YW Installation - Manual (Page 13)

13
You must verify with a qualified electrician that this
grounding method is acceptable before connecting.
OPTIONAL EXTERNAL GROUND
FOR 3-WIRE CONNECTION
1.
Prepare to connect neutral ground
wire and neutral wire
E
B
A
5.
Connect remaining wires
4.
Connect neutral wire
C
B
Remove center terminal block screw (B). Remove neutral
ground wire (E) from external ground conductor screw (A).
Place hooked ends of remaining direct wire cable wires under
outer terminal block screws (hooks facing right). Squeeze
hooked ends together and tighten screws. Finally, reinsert tab
of terminal block cover into slot of dryer rear panel. Secure
cover with hold-down screw. Now, go to “Venting Requirements.”
Place hooked end of neutral wire (white or center) (C) of direct
wire cable under center terminal block screw (B). Squeeze
hooked end together. Tighten screw.
Connect neutral ground wire (E) and neutral wire (white or
center wire) (C) of power supply cord or cable under center
terminal block screw (B). Tighten screw.
Place hooked ends of remaining wires under outer terminal
block screws (hooks facing right). Tighten screws.
Connect a separate copper ground wire (G) from the external
ground conductor screw (A) to an adequate ground. Finally,
reinsert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw. Now, go to “Venting
Requirements.”
2.
Connect neutral ground wire and
neutral wire
C
E
B
3.
Connect remaining wires
4.
Connect external ground wire
G
A