Maytag WED9051YW Installation - Manual (Page 3)

3
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: If installing dryer on pedestal, do not use leveling legs.
Optional Equipment: (Not supplied with dryer)
Refer to your Use and Care Guide for information about
accessories available for your dryer.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See “Electrical Requirements” and “Venting Requirements”
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Parts supplied (all models):
Parts supplied (steam models):
Flat-blade screwdriver #2 Phillips screwdriver
Wire stripper (direct wire
installations)
Tin snips (new vent
installations)
1/4" nut driver
(recommended)
Vent clamps
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Caulking gun and
compound (for installing
new exhaust vent)
Utility knife
Tape measure Pliers
Level
Leveling legs (4)
“Y” connector Short inlet hose
Long inlet hose Rubber washer