MBM Corporation BC 12 - Manual (Page 29)

27
5.13.1 When “E002” is displayed
∗ “E002” indicates the cutter unit may have stopped during cutting operation.
∗ Turn off the power switch, open the top panel, and then open the paper feed unit by loosening the
paper feed unit fixing bracket and lifting the unit.
∗ The cutter unit is installed behind the first delivery roller under the paper feed unit. Check whether it
has stopped cutting paper halfway.
∗ If it has stopped cutting paper halfway, close the paper feed unit and top panel, turn on the power
switch, and press the Ready/Clear Key. Then, the cutter in the cutter unit will then be disengaged.
(The sound of the cutter being released is heard for a moment.)
∗ After turning off the power switch, open the top panel and paper feed unit and remove any paper or
scrap of paper remaining near the cutter unit.
∗ To remove a scrap of paper remaining near the cutter unit, push in an A4 sheet as shown in the drawing
on the next page, then you can easily make the scrap drop into the trash box.
∗ Also, to pull out a sheet of paper stuck in the first delivery roller, gently drop the paper feed unit
further as shown in the drawing. The roller will move up and you can pull out the paper.
∗ After completely removing the remaining sheet or scrap of paper, securely close the top panel and
paper feed unit, turn on the power switch, and press the Ready/Clear Key.
(When closing the paper feed unit, securely tighten the thumbscrew of the paper feed unit fixing
bracket.)
When removing a sheet of paper caught in the cutter unit, be sure to turn off the power
switch before doing so. Otherwise, it may injure your fingers, or cause an electric
shock.
WARNING