MBM Corporation TRIUMPH 5551-06 EP (9 STEP MODULE) - Manual (Page 18)

- 18 -
123456789012345678
123456789012345678
123456789012345678
123456789012345678
EBA 551-06 • EBA 551-06 LT
cm
inch
cm
inch
Start machine
• Main switch
F to position "I", Pull out blade
locking key H .
• Press
S
button Q ➞ backgauge I moves
to the rear and searches for the reference
position, wait until a measurement is shown
in the display
D (57 cm or 22,44 inches).
Warning!
Before storing or cutting a measurement
please check if the correct measurement
scale (cm or inch) see above is stored. For
information on how to store see picture
below left.
Cutting to specified dimensions
• Enter dimension on the numerical key pad
S ➞ LED "S" Z appears. (If a wrong
dimension is entered this can be corrected
by pressing the
s button).
• Press
S
button
➞ dimension is
approached,
➞ LED "S" disappears.
Dimensions below 9 cm can only be
approached with the
S button pressed and
held. (When the S button Q is released,
the backgauge I moves to a measurement
of 9 cm
➞ measurement 9 cm appears,
keep the S button pressed, backgauge I
moves to e.g. 7 cm).
• Insert paper and move by means of the
stacking angle to the backgauge I and side
lay on the left J .
• Release the cut.
Cut according to markings
• Adjust the backgauge with the
hand-wheel G to the back.
• Insert paper and move by means of the
stacking angle to the backgauge I and
side lay on the left J .
• Turn the hand-wheel G to the right until the
marking on the paper to be cut is below the
cutting line indicator.
• The further the hand-wheel G is turned to
the right, the quicker the backgauge moves.
If the hand-wheel is turned to the left the
backgauge will return quicker.
• Release the cut.
• Operation •