MBM Corporation TRIUMPH 5551-06 EP (9 STEP MODULE) User Manual
Page 20
- 20 -
123456789012345678
123456789012345678
123456789012345678
123456789012345678
EBA 551-06 • EBA 551-06 LT
cm
inch
A
Programming
This control system enables you to store 9
programs with 9 programmable steps. One
step represents one measurement. After
entering the program numbers you are able to
change between several program steps with
the button
r
and
h
.
First figure on display = program number.
Second figure = program step.
Dimensions
below 9 cm can only be approached with the
S
button held pressed.
"
u
" on the display
➞ the entered dimension
is too low.
"
o
" on the display
➞ the entered dimension
is too high.
The indicated program step can be
overwritten at any time. These programs
remain stored when the machine is off.
Should you change to another dimension unit
all programmed measurements are converted
into the new unit (cm or inch).
Entering a program
• Press
p
➞
P
appears on the display.
•
1
...
9
Enter program number 1...9.
(First figure on display = program number).
• Enter dimension, or move the backgauge to
the desired measurement with the
hand-wheel (
A).
•
g
Store the dimension
➞ next program
step appears. If the hand-wheel (
A) is used
to approach the cutting position press
button
h
next program step appears.
• Enter the next dimension.
(Should an ejection be desired before this
cut push the
g
button and
r
button
simultaneously).
• Should the entered program be required
immediately
➞ press
S
(program is
closed).
Press
S
again (backgauge moves to the
dimension of the first program).
Or:
•
p
+
S
Escape the program mode.
• Operation •