MBM Corporation TRIUMPH 5551-06 EP (9 STEP MODULE) - Manual (Page 19)

- 19 -
cm
inch
Eject function
If button
r O is pressed instead of button
S Q , after inserting the measurement, the
backgauge will advance forwards to
measurement 9 cm/3,54 inch (standard
setting of the machine) so that paper can be
removed. Finally the backgauge moves to the
last setting.
Adjust the eject-dimension
• Press
p
, press
T
, Press
p
press
T
➞ e on display.
• Insert the desired dimension.
•
g
Store dimension.
Multiple cut
• Enter the multiple cut size on the display
S .
• Advance to the measurement with the
S
button.
• Push the paper to the backgauge I .
• Press
T
button
➞ the red LED "M " a light
will be on.
• Enter the multiple cut size.
• After each cut the backgauge advances to
the next dimension automatically.
• Pressing the
s
button P shows the actual
size.
Exiting program-mode
• Press
T
button
➞ LED "M " a is cleared
on the display.
Cutting activation
Warning!
• Run backgauge to the front for turning the
paper stack.
• Do not interrupt the upward movement of
the blade by performing switching
procedures.
• Release blade only when LED "S" has gone
out.
• Blade must always be at the top and be
covered by the clamp. Do not touch the
blade.
Risk of injury!
• Operation •