MBM Corporation TRIUMPH 5551-06 EP (9 STEP MODULE) - Manual (Page 22)

- 22 -
123456789012345678
123456789012345678
123456789012345678
123456789012345678
EBA 551-06 • EBA 551-06 LT
cm
inch
cm
inch
Working with programs
• Press
p ➞ P appears on the display
•
1
...
9
Enter program number 1 ... 9.
With the button r and h you are able to
change between several program steps. With
S
the backgauge moves to the indicated
dimension. With
s
the backgauge stops.
General
LED "S" blinks
➞ the basic position will
appear. LED "S" is off
➞ the actual dimension
appears. In the program mode the ejection of
paper
r
is not possible. The ejection of
paper has to be programmed.
After each cut the backgauge advances to the
next dimension automatically.
Escape the program mode
• Press
p ➞ P appears on the display.
• Press
s ➞ escape the program mode.
Program buttons h and r programs
Button h = backgauge position rear
Button
r
= backgauge position front
Press
p
and simultaneously
h
( U appears
on the display) or Press p and
simultaneously
r
(
D
appears on the
display)
• Enter the desired dimension (For example:
29,7 cm x 42 cm can be entered for DIN A3)
•
g Store dimension.
Display in cm or inch
Press
i ➞ display changes between cm and
inch (see picture left). Measurements (in cm
or inches) for the rear reference point of the
backgauge are shown on the top of page 18.
• Operation •