MBM Corporation CREASEMATIC AUTO 50 - Manual (Page 24)

Engineer Settings:
Sheet Tolerance: The length of every sheet passed through the machine is measured for
error detection. Adjust this value to regulate stoppages.
Photo to Knife Offset: Distance from the paper detection photocell to the knife. This
setting can be adjusted to give the correct first crease position from the leading edge of
the paper.
Feed Timeout: Feed distance of paper feed roll before a Paper Jam Error is made. This
may be disabled by the button below.
Default Settings are:
Sheet Tolerance
- 50
Photo to Knife offset - 23.5
Feed Timeout - 800
Auto50-ops-touch screen usa 4/3/2013 24