MBM Corporation CREASEMATIC AUTO 50 - Manual (Page 27)

Login Process:
Four login modes are available:
0 User – access to crease positions on all jobs (5)
1 Manager - as above plus access to default speed (8191)
2 Engineer - as above plus access to photocell offset and languages (xxxx)
3 Factory - as above plus access to motor parameters (xxxx)
The LED to the felt of the display indicates the login level.
Access to anything other than crease positions is only available on program 1.
To login:
From start up, press continue at any time to start. If a valid code is not entered, login
defaults to ‘user’.
To login adjust the present digit with the ‘up’ and ’down’ keys, when correct press the
‘right’ key to advance to the next digit. When the last (forth) digit is correct, press the
‘continue’ key.
Auto50-ops-touch screen usa 4/3/2013 27