Measurement Computing DaqScan 2000 Series - Manual (Page 40)

6-6 Configuring the System for Operation 947091 DaqLab/2000 Series & DaqScan/2000 Series
STEP 5 – Configure the Computer’s Network Settings [Applies to “dedicated networks” only]
If using a LAN (Local Area Network), which has a DHCP server, skip this section
and continue with STEP 7 - Configure and Test the System using the
Daq*Configuration Applet (page 6-10).
If using a LAN (Local Area Network), which has no DHCP server, skip this
section and continue with STEP 6 - Configure Device Network Settings using
DaqIPConfig (page 6-9).
1. Open the Control Panel by navigating from the Windows Desktop as follows:
Start Menu Settings Control Panel.
2. Double-click the “Network and Dial-up Connections” icon.
3. Double-click the “Network Connection” icon for the network that the Daq device is
connected to.
Local Area Connection Status
4. In the “Local Area Connection Status” box (previous figure), click on the <Properties>
button. The “Local Area Connection Properties” box will appear (following figure).