Measurement Computing PCM-DAS16x/16 - Manual (Page 35)

10 CABLE & SCREW TERMINAL BOARD
The PCM-C37/33 is a 10 inch 33 conductor cable assembly for use with 33 pin
PCMCIA cards. The PCM-C37/33 has a connector on one end and a 37 pin D type
connector at the other. The chart below describes the color coding of the wires for
each of the 33 pins.
Green/Yellow 33 White/Black 22 Grey 11
Green/Red 32 White/Red 21 Lt Brown 10
Orange/Red 31 Green/White 20 Purple 9
Red/Green 30 Orange/White 19 Yellow 8
Red/Orange 29 White/Green 18 Blue 7
Blue/Red 28 White/Orange 17 Orange 6
Grey/White 27 Brown/White 16 Brown 5
Red/Blue 26 Blue/White 15 Green 4
White/Grey 25 White/Brown 14 White 3
Black/White 24 White/Blue 13 Red 3
Red/White 23 Pink 12 Black 1
COLOR PIN COLOR PIN COLOR PIN
If you want to wire directly to your signal source, simply cut off the 37 pin connector
and wire up the signals using the color to pin number guide above.
If you wish to use a screw terminal board, please purchase a CIO-MINI37 and connect
it to the 37 pin connector end of the cable. Of course pins 34 to 37 will not have any
function. Use the PCM-DAS16x/16 connector diagram elsewhere in this manual to
determine the function of the signals at the screw terminals. The screw terminals are
numbered 1 to 37, and the cable is wired so pin 1 of the PCM board connects to pin 1
of the screw terminal, and so on.
31