Montigo H38DF ST - Manual (Page 26)

H*38DF ST Indoor Gas Fireplace
Page 26
XG0207 - 150204.1
Installation
Section 8: Installing the Accessories
Figure 25a. Place Logs' "A" on Left & Right stands.
Installing the Logs and Embers
Bottom Logs
The H38DF*-ST is supplied with eight (8) fibre logs. The two small bottom
logs ("A" ) are mounted on the burner grate by placing them diagonally
onto the supplied Log stands. The long Front / Back logs ("B") are
placed against the grate as shown in Figure 25b. Note: When placing
logs, arrange Logs "B" as not to cover Burner holes.
Top Logs
Next are the logs "C" which are placed diagonally, as shown in Figure
25c. The last Logs "D" are then mounted on top of logs "A" as shown
in Figure 25d. Figure 25c. Log Installation. (Place Logs' "C" on-top of Logs "A".
Indentations on-top of Logs' "A"
Figure 25b. Place Logs' "B" as shown, in front of Right-hand "A", and
behind Left-hand "B".
Log A
Log B
Log C
Log A
Log B
Log C
Figure 25d. Completed Installation.
Log D
Log D
Figure 25. Empty firebox showing the Left & Right stands.
Front of Fireplace
Burners
Log Stand
Log Stand
Burner holes (front & back burner),
note hole pattern when placing logs
Air Inlets
Installing the Ember Material
The ember material is supplied in two packages. Place the material
evenly, forward of both Log stands, under logs 'A' and 'B', also forward
from Logs 'C' & 'D'. Refer to figure 25b. Ensure the burner holes are
free of ember material after placing the embers.
If logs are not placed properly, excessive sooting will result.
NOTICE