Montigo DHS - Manual (Page 10)

Page 10
Hotshot Gas Fireplace Insert
XG0511 - 150203
Installation
Step 4. Install the Upper Louvre Assembly
Position the Upper Louvre Assembly on top of hood on an angle
as shown in Figure 9a. Line up the Upper Louvre horizontal to the
fireplace skirt.
Slide the face plate trim onto the fireplace. The trim should slide in
easily between the face plate and the lower louvres and the hood.
Refer to figure 8b. Ensure that the pilot holes in the trim line up
with the pilot holes in the face plate.
Install two screws into the pilot holes in the top rail, and one screw
into each of the side rails, as shown in figure 8b.
To remove face plate or face plate trims simply reverse above
procedures.
Figure 8b. Installing the trim.
Figure 9a. Installing the upper louvres.
Figure 9b. Installing the upper louvres.
Raise the Upper Louvre over the heat deflector, ensuring the heat
deflector is positioned between the bottom and middle louvre.
Figure 9c. Completed installation of Upper louvres.
Push Upper Louvre flush to the fireplace. Fasten Upper Louvre to
fireplace.
Heat Deflector
Top Louvre
Heat Deflector
Heat Deflector
NOTE: Remove the protective plastic coating from the louvres and
trim before lighting the appliance. Failure to do so will result in
permanent damage to the metal's surface.