Installation, Installing the log set – Montigo DHS User Manual

Page 13

Advertising
background image

Page 13

Hotshot Gas Fireplace Insert

XG0511 - 150203

Installation

2. Unpack the logs. Be sure to handle the logs carefully, as they are

very fragile.

3. Place the Back log onto the back log rest as shown below in

figure 12a. The log has lip on the bottom which fits into the slot

on the log rest.

4. Place the Front log onto the front log rest as shown in figure

12a. Centre the log from side to side, and push it against the

back of the log rest. Carefully push the log onto the metal spikes

on the log rest.

5. Place the top logs in position as shown in figures 12b and 12c.

5. Start the fireplace. If the flame appears satisfactory, replace the

glass door and door cover.

Figure 12a. Positioning for the top logs ('C' and 'D' ).

Installing the Log Set

Installing the Logs:

The double burner Hotshot is supplied with a six (6) piece fibre log

set.
1.

Remove the door cover and the glass door.

Back log

Left log

Right log

Front log

Center logs

Figure 12b. Proper placement (top view).

Back log

Front log rest

Back log rest

Heat exchanger tubes

Front log

Front burner tube

Back burner tube

Ember tray

Back log

Left log

Right log

Front log

Center logs

Figure 12c. Log placement as seen from the front of the stove.

NOTES

:

If the logs are not placed properly, excessive sooting

will result.

The surface of the logs will crack due to the heat from

the flames. This is a normal occurrence

Advertising